Anthem Statement D1 Betriebsanleitung PDF herunterladen (Seite 22)

4.1 CONNECTING POWER TO THE STATEMENT D1

Connect the power cord to the back of the Statement D1 and then to a 105 to 130 Volt, 60 Hz AC outlet.

4.2 AUDIO CONNECTIONS

There are two methods of transmitting audio signals: Analog and Digital. Analog is an electrical waveform

representation of sound and requires one cable for each channel. Digital represents sound using a sequence

of numbers and requires only one cable for all channels.

Every audio input in the Statement D1 can be changed from the factory setting to either Digital or Analog,

except 2-Ch BAL and 6-Ch S/E, which accept analog signals only (see section 7.4.5).

4.2.1 DIGITAL AUDIO INPUTS AND OUTPUTS

Digital Audio-In connections are made through a coaxial (RCA), optical (TOS), or balanced (XLR) cable. From

the factory, DVD and SAT are set to Digital-RCA, whereas CD, TAPE, TV, VCR, and AUX are set to Analog-DSP.

The highest transmission quality is achieved with the AES/EBU connection. The Statement D1 provides one

such input. The S/PDIF-RCA connection offers the next best digital transmission – use for source

components with digital RCA outputs. For source components with Toslink outputs only, use S/PDIF-TOS. Any

digital input may be assigned to any number of Sources that are set to ‘Digital’ (see section 7.4.5).

Note: An external RF demodulator is required if using a Laser Disc player with Dolby Digital/AC-3.

Digital Rec-Out can provide a signal to the digital audio input of a Mini Disc recorder, CD-R, etc., from any

Source set to ‘Digital’ or ‘Anlg-DSP’ (see sections 7.4.5 and 7.4.7).

4.2.2 ANALOG AUDIO INPUTS

Left/Right Analog audio connections are made through a pair of interconnect cables – typically white or

black for the Left channel and red for the Right channel.

Note: Connect both the digital and

analog outputs from source components that have both types of

connection (e.g. DVD player) – ZONE2, ZONE3, and RECORD require analog audio connection

unless set to ‘copy’ MAIN (see sections 5.2.1 and 7.4.5).

Caution for DTS: With DTS-CDs or DTS Laser Discs, do not use analog connection if your player does not

have the DTS logo on its faceplate, otherwise a loud noise will be produced at the analog outputs of the

player. Players that have the DTS logo can pass a DTS-encoded signal through their digital outputs, though

they do often require a change in their setup menu to enable it (see player’s operating manual).

4. CONNECTIONS

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 85 86

Keine Kommentare

Anthem Statement D1 Betriebsanleitung Seite 22